Netgear WNDR3700
How to Factory Reset the Netgear WNDR3700 Wi-Fi Wireless Router
- Make sure your Netgear WNDR3700 is powered on.
- Locate the factory reset button on the back of the WNDR3700 router.
- Using a paper clip or similar pointed object, press and hold the reset button for at least 7 seconds.
- Release the button and wait 2-3 minutes for the router to fully reboot.
- You can now reconfigure your WNDR3700 using the default credentials below.
NOTE: If the factory (also known as hard) reset button on your Netgear WNDR3700 is too small to push with your finger, try using an object such as the tip of a paper clip.
This is often the best way to press the reset button on Netgear routers.
Netgear WNDR3700 Default Login Credentials
After performing a factory reset, your Netgear WNDR3700 will be restored to its default settings. Use the following credentials to access the router’s admin panel:
- Default IP Address: 192.168.1.1
- Default Username: admin
- Default Password: password
Open a web browser and navigate to 192.168.1.1 or http://www.routerlogin.net to access the Netgear WNDR3700 setup page.
About the Netgear WNDR3700
The Netgear WNDR3700 (N600) is a simultaneous dual-band Wireless-N router with combined speeds up to 600 Mbps (300 + 300 Mbps). It features five Gigabit Ethernet ports (one WAN + four LAN), one USB 2.0 port for shared storage or printer access, an integrated SPI firewall, WPA/WPA2 wireless security, and supports the Netgear Genie app. The WNDR3700 is notable for its open-source firmware compatibility with DD-WRT and OpenWrt.
Specifications
| Manufacturer | Netgear |
|---|---|
| Model | WNDR3700 |
| Wi-Fi Capable | Yes |
| Reset Capabilities | Factory Reset, Hard Reset, Soft Reset |
