Netgear Nighthawk AC1900 (D7000)

How to Factory Reset the Netgear Nighthawk AC1900 (D7000) Modem Router

1. Make sure your Netgear D7000 is powered on.
2. On the back of the modem router, locate the Reset button to the right of the leftmost antenna.
3. Using a paper clip or similar pointed object, press and hold the reset button for at least 7 seconds.
4. Release the button. The Power LED will start blinking amber as the configuration resets to factory defaults.
5. Wait approximately 2 minutes for the modem router to fully reboot.
6. You can now reconfigure your D7000 using the default credentials below.

NOTE: If the factory (also known as hard) reset button on your Netgear D7000 is too small to push with your finger, try using an object such as the tip of a paper clip.

This is often the best way to press the reset button on Netgear routers.

Netgear D7000 Default Login Credentials

After performing a factory reset, your Netgear D7000 will be restored to its default settings. Use the following credentials to access the modem router’s admin panel:

• Default IP Address: 192.168.0.1
• Default Username: admin
• Default Password: password

Open a web browser and navigate to 192.168.0.1 or http://www.routerlogin.net to access the Netgear D7000 setup page.

About the Netgear Nighthawk AC1900 (D7000)

The Netgear Nighthawk AC1900 (D7000) is a dual-band Wi-Fi 5 (802.11ac) VDSL2/ADSL2+ modem router with combined wireless speeds up to 1,900 Mbps. Please note that the D7000 is a modem router (gateway) — it includes a built-in DSL modem and does not require a separate modem. It features a dual-core processor, three external antennas with beamforming+, four Gigabit LAN ports, one Gigabit WAN/LAN port, two USB ports (one USB 3.0 + one USB 2.0), and supports Dynamic QoS, ReadySHARE for USB storage, and guest network access.