Netgear WG302
How to Factory Reset the Netgear WG302 Wireless Access Point
- Make sure your Netgear WG302 is powered on.
- Locate the factory reset button on the side of the WG302.
- Using a paper clip or similar pointed object, press and hold the reset button for at least 7 seconds.
- Release the button and wait 2-3 minutes for the device to fully reboot.
- You can now reconfigure your WG302 using the default credentials below.
NOTE: If the factory (also known as hard) reset button on your Netgear WG302 is too small to push with your finger, try using an object such as the tip of a paper clip.
This is often the best way to press the reset button on Netgear devices.
Netgear WG302 Default Login Credentials
After performing a factory reset, your Netgear WG302 will be restored to its default settings. Use the following credentials to access the admin panel:
- Default IP Address: 192.168.0.230
- Default Username: admin
- Default Password: password
Open a web browser and navigate to 192.168.0.230 to access the Netgear WG302 configuration interface.
About the Netgear WG302
The Netgear WG302 is a ProSafe 802.11g wireless access point designed for small and medium business environments. Please note that the WG302 is an access point, not a standalone router — it must be connected to an existing router or gateway to provide internet access. It features one 10/100 Ethernet port with PoE (Power over Ethernet) support, dual detachable antennas, 802.1Q VLAN support, and supports up to 64 simultaneous wireless clients with WPA/WPA2-Enterprise (RADIUS) security.
Specifications
| Manufacturer | Netgear |
|---|---|
| Model | WG302 |
| Wi-Fi Capable | Yes |
| Reset Capabilities | Factory Reset, Hard Reset, Soft Reset |
